How to make a reverse reverb vocal riser (FL Studio)
A reverse reverb riser is the ghostly swell that rises out of nothing and "sucks" into the first word of a vocal. It's a staple in pop, EDM, trap and film trailers. Here's how to make one by hand, and why it takes so many steps.
What you're actually making
The trick is a reverb tail played backwards. Normally a reverb tail starts loud and fades out after a sound. Reverse the vocal before the reverb and reverse the result again, and the tail now fades in, ending right where the vocal begins.
The manual method, step by step
- Isolate the first phrase. Copy the start of the vocal, usually the first word or two, into its own clip. In FL Studio you can slice it in the playlist, or open the audio in Edison and select just that part.
- Reverse it. In Edison, use the Reverse tool. For a clip in the playlist, enable Reverse in the audio clip's channel settings.
- Add a reverb at 100 % wet. Route the reversed clip to its own mixer insert and add a reverb (Fruity Reeverb 2 or any reverb you like). Set it fully wet, with a long decay (4–10 s) and a large size. You only want the tail, not the dry vocal.
- Render the reverb, including the tail. Render the insert to audio and make sure the render keeps the full reverb tail after the clip ends; otherwise the swell gets cut off.
- Reverse the render. Reverse the new audio file again. The tail now builds up instead of fading out.
- Line it up. Place the rendered clip so its end lands exactly where the vocal starts. Zoom in and nudge it until the swell flows into the first word without a gap or a flam.
- Tidy up. Add a fade-in at the start, filter out low-end mud (a high-pass around 150–250 Hz), and balance the level against the beat.
That's seven steps for one riser. Change the reverb, try a different word, or move to the next chorus, and you do most of it again.
Tips for a better swell
- Feed it enough vocal. A very short slice gives a noisy whoosh. A second or two keeps the character of the voice in the swell.
- Pre-delay changes the shape. More pre-delay pushes the peak of the swell earlier, leaving a small gap before the vocal.
- Keep it out of the way. Cut the lows, and consider a high cut so the swell doesn't compete with the vocal's top end.
- Try a pitch rise. A small upward pitch bend into the vocal adds tension, especially before a drop.
The one-step way: Inhale
We built Inhale because we were tired of doing the steps above. Put it on the vocal track, press ARM and play the song. It captures the first phrase, renders the reverse reverb swell instantly, and ends it sample-accurately where the vocal starts. Tweak any knob and it re-renders; then drag the riser straight into your playlist.
Published 22 November 2026 by Ninth Wave Audio. FL Studio is a trademark of Image-Line Software.